In the configuration tab: Select the series (forecast series) for which you want to make changes in the table grid in order to show the settings for the series. Click on the arrow for Model to adjust the settings for the model connected to the series. The image below shows the properties window for the model settings. At the very bottom on the right, time indications are set for when the data status check is to warn of missing data.

The default setting is -999; this setting means that no check is performed for data status. In this case information about the latest data or information about warnings of missing data will not be displayed in the data status window.

“Max hours to load data”

Here you enter the maximum number of hours you will permit load data to be missing from the start of the forecast and backwards in time before you get a warning.

“Max hours to weather observation”

Here you enter the maximum number of hours you will permit historically observed weather data to be missing from the start of the forecast and backwards in time before you get a warning.

“Max hours to weather forecast start”

Here you enter the maximum number of hours you will permit the weather forecast to start before the load forecast start. This is so that you get a warning if a weather forecast that is too old is used in the forecasting.

“Min hours to weather forecast end”

Here you enter the number of hours a weather forecast must be present forwards in time from the load forecast start, This is so that you get a warning if the weather forecast applies for too short a period forwards in time, with the result that normal weather may be used in the forecast.